
axisClip3               - Fixes the weight pulley on the axis. Two required.
brakelineHolder3        - Two are required. 
laserCage2              - Holder for the Leica DISTO D110.
laserTrolley3           - Requires 5 mm screws. 
laserTrolley4           - Allows for 6 mm screws, has less overlap support for top bearing.
measureRailStopPlate1   - End stop for both ends of the measurement ruler and the front end of the riser ruler. So three are required.
pulleyFiller3           - Filler between bearing and cylinder, Two are required.
riserRailPulleyPlate3   - End stop and pulley axis support. Two are required, one a mirror image of the other
riserTrolley1           - Requires 5 mm screws. Two are required.
riserTrolley2           - Allows for 6 mm screws, has less overlap support for top bearing. Two are required.
targetPlateBlock2       - Target plate and the block to clamp it to the riser profile.
weightBottom3           - Cap for both top as bottom of the weights, when you have two of 38 mm and one of 25 mm diameter.

fjkraan@xs4all.nl, 2019-05-11